ENCAD T-200 Manual de usuario descargar pdf (Pagina 9)

T-200+ Technical Guide

8. Cartridge Warranty

The foam-filled cartridge replacement is a user clean-hands replacement. Image quality and

warranty will be determined based on the default 4-pass (Normal) mode image quality. If 10 jets

(per cartridge) are electrically failed with less than 165 ml of ink throughput then the

cartridge warranty will be honored; clogs should be cleared using the manual electronic jet

compensation. The cartridges will be warranted for 165 ml ink throughput (approximately 3 snap-

on reservoir replacements) with cartridge shutoff at 350 ml (approximately 7 snap-on reservoir

replacements maximum). Cartridges replacement is authorized by ENCAD technical support in

the US and Canada only. All other printer problems must be analyzed by the appropriate service

provider as follows: printer service in the US and Canada is handled by the ENCAD technical

support and service center only; for all international support issues please contact the point-of-

purchase ENCAD dealer or the authorized service provider in respective region. Any questions

please call 1-800-45-ENCAD.

NOTE: Additional checklist for possible cartridge replacement:

A. Electrically bad jets (100% filled block) in the Prime pattern (5 for Gray-top cartridges;

10 for Red-top cartridges) and <500 ml throughput (see UTILITY MENU – SERVICE

MENU – CARTRIDGE INFO) warrants a cartridge replacement. Manually bypass

clogged jets as necessary (clogged jets, misfires, are not covered by the warranty.)

Clean the jet plate thoroughly by

blotting with a water dampened

lint-free towel to clear clogs.

- Catastrophic Jet Failure (more than 35 jets)

- Faulty Power Line; check

compensation list

to verify photo mode is still

supported. Clean rear electrical

contacts and reseat cartridge to

verify problem is not intermittent.

- Faulty Address Line; check

compensation list to verify photo

mode is still supported. Clean

rear electrical contacts.

- Multiple Power and Address

line failures; one cartridge is

defective (use post-it note

technique to isolate defective

cartridge.)

- A clogged jet is illustrated as jet 111; jets 105 and 108 are manually bypassed (80%

filled blocks only.) Jet 114 is defective and is automatically being bypassed. Between 20

and 35 jets, in each color, may be defective or bypassed to maintain photo quality

printing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 98 99

Sin comentarios

ENCAD T-200 Manual de usuario Pagina 9