ENCAD T-200 Manual de usuario descargar pdf (Pagina 10)

T-200+ Technical Guide

B. Micro-banding is typically caused by the low pass modes or improper color deadband

and color calibrations. If calibrations are satisfactory, then jet degradation of one color

probably exists. Inspect prime pattern for diagonal line integrity and consistency (line

should be perfectly straight with no misfires). Check item #3 below.

C. Prime pattern line observed to be

shifting up and down randomly (i.e.

see faulty K line in photo at right);

check print-pass mode. Replace

cartridge if problem cannot be

resolved.

D. Ink Starvation (caused by the Cartridge and not the Ink Delivery System); defective jet

plate seal or top lid seal. Test alternate ink delivery lines and tubing needles before

cartridge replacement. Swap cartridge positions to check electrical connectivity.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 98 99

Sin comentarios

ENCAD T-200 Manual de usuario Pagina 10