ENCAD T-200 Manual de usuario descargar pdf (Pagina 7)

T-200+ Technical Guide

" Operating Systems; Novell Netware 3.x – 5.x, UNIX, BS2000, Apple MacOS 7.x –

9.x, Microsoft Windows 3.X, 95/98, NT 4.X, 2000

" Easy Installation and Simple Management

" JetAdmin, WebJetAdmin, and EpsonNet Tools Support

B. To reset the server: depress the blue test button (on side of server) for three seconds while

SEH is disconnected, continue to hold button and plug server into parallel port (power applied to

printer), then release button after 3 seconds. Press and hold blue button again for three more

seconds and release. The IP address should be reset to 0.0.0.0 when performed correctly.

C. The Status and Link LED’s (green in color) should be steady when the T-200 has been turned

on and a properly configured network connection has been established. The Status LED will

blink until the server is configured properly in the proper IP range of the device (could be

dependent of the HUB’s or Network Interface Card’s IP range). The Activity LED (amber in color)

will only blink while the server receives data from the host computer (typically blinks during

printing).

1 2 3 4 5 6 7 8 9 10 11 12 ... 98 99

Sin comentarios

ENCAD T-200 Manual de usuario Pagina 7